ESSAI de 14 jours

Choisir langue

Anglais
Tchèque
Allemand
Espagnol
Français
Italien
Néerlandais
Hongrois
Roumain
Reinforced concrete ledge beams via CSFM
Webinar

Reinforced concrete ledge beams via CSFM

Concrete
Detail 2D
Beam
CSFM
Double ledge beam

    Date de webinaire:

  • 2021-09-01T00:00:00.0000000Z
    (en votre temps local, format 24 heures)

Rejoignez le webinaire pour savoir plus de

  • What are the problems encountered when designing beams with ledges
  • How the CSFM method gives you more reliable answers
  • How IDEA StatiCa Detail compares and improves on the traditional methods

Lecteurs

Petra Komarkova
Petra Komarkova Product Engineer
IDEA StatiCa
Klara Thielova
Klara Thielova Consultant
IDEA StatiCa
Do you design precast concrete structures and facing problems when you design and check ledge beams? Do the tried and tested traditional methods of analysis leave you doubting if they are good enough? If the answer to one or more of the above questions is yes, then our next webinar is a place to be.

In the webinar, we will discuss the problem of ledges of L- or (inverted) T-shaped beams. The typical examples from the practice of precast reinforced concrete structures will be presented. We will outline a possible workflow of design and check of the ledge beams. 

First, we start working in IDEA StatiCa Beam to design and check the beam in the longitudinal direction. Then, we go to IDEA StatiCa Detail, where the discontinuity region – ledge beam in transverse direction will be modeled. Such a concrete member will be reinforced, subjected to the loads, and analyzed via CSFM. We will go through the results and assess the detail for limit states, both ultimate and serviceability. Finally, we will compare the results obtained using the Strut-and-Tie method with the results provided by CSFM.

In the first step, the ledge L-shaped beam is analyzed in the longitudinal direction. It is necessary to model the beam in 3D in order to capture eccentrically acting load effects. The stirrups are designed for shear and torsion in the longitudinal direction.

Ledge of a L-shaped beam subjected to the line loads

In the second step, a transverse transmission of loads is analyzed. In addition, the stirrups designed in the first step must safely transmit the tension caused by acting loads on the ledges to the longitudinal direction of the beam.

Topology optimization of a ledge L-shaped beam

Compatible stress field method (CSFM) is implemented in the IDEA StatiCa Detail app. This method was developed to design and code-check reinforced concrete details, especially the discontinuity regions and walls. Validation and verification of the CSFM solution is an essential part of the process of IDEA StatiCa software development. There has been extensive research done in this field, which is available on the IDEA StatiCa webpage and in the book Compatible Stress Field Design of Structural Concrete by prof. Kaufmann.

IDEA StatiCa Beam provides an economic and complex design for your everyday engineering work. We use cutting-edge methods for FEM modeling and nonlinear checks for ultimate, and serviceability limit states. According to Eurocode (EN) and SIA, the code-checks are performed for bridges of small and medium spans, buildings, and liquid retaining structures. Always according to the latest code updates and national annexes. A wide range of possibilities in check settings covers cast-in-place, precast and composite structures.

Webinar recording